If you have aggregates on your driveway, make sure they stay there - with Bradstone's Driveway edging. It's a smart, durable and cost effective way to confine aggregates to your drive and also looks just as good skirting tarmac or block paving.
There are approximately 1.1 edgings per linear metre, therefore, one pack of 90 units will cover 81 linear metres assuming that the product is butt jointed.
Deliveries normally occur between 7am and 6pm. Once your order has been placed you will be contacted and provided with an exact date of delivery.
This vehicle will lower the product to the ground using an electric lift. The pallet of products is then pulled off using a manual pallet truck. It is imperative that the ground that the pallet is unloaded onto is flat and solid. Access may be needed for a rigid lorry (up to 20ft) otherwise additional delivery charges may be made. For larger orders alternative delivery methods can be arranged. Please call our office to discuss any delivery requirements or for clarification.
Our customer services team will advise how to prepare for receipt of ordered goods. Our delivery team are not responsible for any additional lifting or carrying of your goods.
We do not deliver items to multiple addresses.
All full packs and all orders containing at least one full pack will be delivered free of charge*.
Delivery charges for individual units usually have a flat charge of £30. *Delivery is free on orders with full packs except for deliveries to the postcodes AB, BT, DD, GY, HS, IM, IV, JE, KA27-28, KW, PA20+, PH, P030-41, TR21-25 and ZE (please call 0800 032 6306 for a quote).
Delivery will normally be less than 7 days (typically 3-5 working days). Simply Paving will aim to contact you by email or directly by phone within two working days of your order to suggest a delivery date. If the date provided is unsuitable please get in touch and we will re-arrange the delivery date.
For further information please refer to our Delivery Policy
Whilst some edgings can be laid directly into the ground, to increase stability, a more permanent method of fixing is recommended.
This is achieved by digging a small foundation trench to the required length, approximately 100mm deep and 150mm wide. Lay concrete foundations using 6 parts ballast to 1 part cement (or 4 parts coarse aggregate to 2 parts building sand to 1 part cement).
Once the foundation mix has cured, bed the edging by gently tapping the top edge with a rubber mallet into a mortar bed of 4 parts building sand to 1 part cement, ensuring each unit is aligned and level. Back fill the reverse face of the edging with the same mortar mix “haunched” with a 45 degree wedge of mortar to a height that will be concealed by the finished surface.