If aesthetics are lower down your list of priorities, and you're simply looking for a hard-working, durable and cost effective paving, Peak Paving is definitely the answer.
Available in two options, Riven and Smooth, Peak is great as a base for utility areas or sheds. (Not recommended for feature patios)
Available in three shades and up to three sizes.
Each pack contains 20 units.
When laid using a 10-15mm joint each pack contains enough paving slabs to cover 7.44m2.
Deliveries normally occur between 7am and 6pm. Once your order has been placed you will be contacted and provided with an exact date of delivery.
This vehicle will lower the product to the ground using an electric lift. The pallet of products is then pulled off using a manual pallet truck. It is imperative that the ground that the pallet is unloaded onto is flat and solid. Access may be needed for a rigid lorry (up to 20ft) otherwise additional delivery charges may be made. For larger orders alternative delivery methods can be arranged. Please call our office to discuss any delivery requirements or for clarification.
Our customer services team will advise how to prepare for receipt of ordered goods. Our delivery team are not responsible for any additional lifting or carrying of your goods.
We do not deliver items to multiple addresses.
All full packs and all orders containing at least one full pack will be delivered free of charge*. All orders of £300 or more (even if only containing individual units) will be delivered free of charge*. Orders for individual units with an order value of less than £300 usually have a flat delivery charge of £30.
*Delivery is free on orders with full packs except for deliveries to the postcodes AB, BT, DD, GY, HS, IM, IV, JE, KA27-28, KW, PA20+, PH, P030-41, TR21-25 and ZE. Please refer to our Delivery Policy
for a table of charges or if you would like further information please call 0800 032 6306.
Delivery will normally be less than 7 days (typically 3-5 working days). Simply Paving will aim to contact you by email or directly by phone within two working days of your order to suggest a delivery date. If the date provided is unsuitable please get in touch and we will re-arrange the delivery date.
For further information please refer to our Delivery Policy
The area to be paved should first of all be dug out to a depth of at least 200mm. The area should then be back filled with 150mm of MoT/crusher run, compacted to 100mm.
As manufactured paviors are produced in man-made moulds, variation in thickness is not generally an issue, and the undersides of the slabs are more consistent. Therefore, for light use patios, a screed bed of a sharp sand and cement mix (a ratio of 6:1 is more than adequate) can be used as oppose to creating a mortar bed.
If preferred, manufactured paving can also be laid on a mortar bed, but it is not always necessary.
Once in place, each flag can be consolidated by tapping them down, either with a rubber mallet or by keeping a piece of softwood between a hammer or mallet and the flag. Continually check levels and falls during the laying process across the top surface profile of a number of flags at a time.
Manufactured paving can be pointed with a wet mortar mix, however great care must be taken to ensure it is not left on the surface of the flag as this will be almost impossible to remove when set. Many people choose to point manufactured paving with either a dry mix of sharp sand and cement brushed into the joints or a specifically designed jointing compound.
If pointing with a dry mix, a ratio of 6 parts sharp sand to 1 part cement is recommended. The dry mix should then be indirectly watered, i.e. lightly water the surface of the flags rather than the pointed joint itself. The water will then trickle into the joints and hydrate the cement, rather than splash the dry mix over the surface of the flag.
Please refer to the guides section of the website for further information regarding laying flag paving.